Tescar CF3

Tescar

CF3

Piling rig

For tight, low-headroom sites and sensitive surfaces

800 to 1,000 mm

Max diameter

22 m

Max depth

11 to 13 t

weight

Camera placeholder image

At a glance

What the CF3 can do on your site

Technical Specifications

Figures are manufacturer maximums. What’s achievable on a job depends on the tooling and the ground.

Suitable applications

  • Bored piles, low headroom
  • Piling on finished surfaces
  • Close-to-wall piling

Site access

Rubber tracks and a narrow footprint suit finished surfaces and tight spaces. Transport width about 2.2 m.

About this rig

Overview

The Tescar CF3 is our lightest piling rig and the one we use when access is the constraint. It runs on rubber tracks, so it can work on finished surfaces and in spaces the rest of the fleet cannot reach, and its transport width is around 2.2 m.

The mast folds down for low headroom work. In low headroom mode the rig works under 3.96 m, and in super low headroom mode it works under 3.28 m, with shorter kelly bar sections to suit. With a 22 m locking kelly bar it reaches 22 m deep in standard mode. It drills bored piles up to 800 mm in diameter, or 1,000 mm in soft soil, with 35 kNm of torque.

That is a lot of capability for 11 to 13 t. It sits below the Soiltek S60 in size and above the MAIT Baby Drill, which gets us a matched rig for each level of restriction. We choose the CF3 when the pile specification is modest and the headroom or surface condition rules out the S60.

Where the job needs larger diameters, deeper piles or a rock socket, we use the Soilmec SR-45 on open ground or the S60 under structures.

Transport and Set-Up

Transport height 2.94 m, length 4.86 m, width 2.2 m (CF3 S catalogue). Float or semi, set-up time, assist needed.

On site

The CF3 at work

Why this rig

Key features

  • Rubber tracks for finished and sensitive surfaces
  • Low headroom mode to 3.96 m, super low mode to 3.28 m
  • Bored piles to 1,000 mm in soft soil
  • 22 m depth with locking kelly bar
  • Transport width about 2.2 m

FAQs

CF3 questions

Can the Tescar CF3 pile on a finished floor or surface?
Its rubber tracks are designed to protect fragile floors, and it sits on surfaces the rest of our fleet cannot. The floor loading still needs an engineer’s check before we mobilise.
When headroom is lower than the S60’s shortest mast allows, or the surface is sensitive and the pile specification is modest.
No. In low headroom and super low headroom modes the kelly bar runs in shorter sections, so the reachable depth drops. We confirm the depth against the clearance on each site.

Not sure which rig suits your site?

Send through your details and a few words about the project, and a member of our team will reach out to talk through your site and the right rig for the job.

The Fleet

Other rigs in the fleet

Camera placeholder image

Tescar

CF3

For tight, low-headroom sites and sensitive surfaces

Camera placeholder image

Tamrock

Ranger 700

For anchor and soil nail holes through rock

Soil Tek S60 Piling Works Under Concrete Viaduct

Soiltek

S60

For piling under bridges, viaducts and low structures